• 💪 Hello, please SIGN-UP FOR A FREE account and become a member of our community!
    You will then be able to start threads, post comments and send messages to other members. Thanks!
  • 🔥 Kits4Less.com #1 MOST LAB-TESTED SOURCE — 25% OFF YOUR FIRST ORDER! 🔥

Really bad PIP with test-e 300mg

N

noitangidni

Registered
Joined
Oct 5, 2014
Messages
37
Reaction score
1
SB Labs
As the title says..

Highly doubt it's my technique due to three main key factors:

I was a flight medic in the military for 8 years, so I understand site rotation, proper BSi procedures.
I also use Tren-E 200mg from monster labs and Equipose 200mg from another lab, using the same sites as my test-e shot sites during rotation and experience zero pip.
This isn't my first rodeo.

Right now my cycle is 300mg test-e M and F (600wk)
200mg tren-e 200mg equi every Saturday.

I've gotten to the point where I can only bare using each rear delt since if I use the medial delts, I won't be able to raise my arms laterally past 90degrees. I've tried, ventro, glute, quad, medial, all horrible and immobilizing pain.

I've been a customer since medlabs and I've always had some pip from test-e but I used to only run 300 a wk to cruise with so the pain is manageable. Now that I have a show coming up in 14 weeks, the swelling, a little redness, no heat, makes me worried about posing and looking slightly awkward on stage with lumps on my delts.

As you can see, I still have lots of gear left. Was this just a bad batch? I've gone through 2 vials with the same issues. Any help appreciated. Yes, I've tried running the syringe through hot water prior, yes I use a drawing needle and a 27g 1 1/2 to pin.
 

Attachments

  • IMG_0537.jpg
    IMG_0537.jpg
    698 KB · Views: 126
I have used their Test C for ages and it’s super good but I also had a problem with the E and switched to C. I do that with every sponsor now and don’t get issues with C but for some reason E doesn’t like me. I would hit up One if the reps and see what can be done for you
 
I've used monster before, never had a problem. If you can't pin on ALL the locations you just mentioned and you know what your doing, something must be wrong. I have never used their test e, only test c and deca which ram smooth everywhere.

Sent from my SM-G930V using Tapatalk
 
1 and a half for rear dealts seems a bit much. Might be hitting sensitive tissue. Have you tried other lengths? For delts I use a half inch or 5/8 but I'm very lean.

Sent from my SM-G930V using Tapatalk
 
Ah, medlab :)

You have a history of pip with E? I think you’ve answered your own question and probably need to switch esters.

Alternatively, split your pin to two sites, each with half the volume so it will be manageable as before.
 
Mr. T said:
I've used monster before, never had a problem. If you can't pin on ALL the locations you just mentioned and you know what your doing, something must be wrong. I have never used their test e, only test c and deca which ram smooth everywhere.

Sent from my SM-G930V using Tapatalk
Click to expand...

I think you didn't read my whole post. I said the rear delt is the only bearable site I can tolerate for test e. I've pinned every location I mentioned with the other gear including test-e, I only run into issues with test-e. I won't get to my muscle with a 5/8 needle even on my rear delts. 1 inch yes, I don't need to go all the way with a 1 1/2 inch needle.
 
noitangidni said:
I think you didn't read my whole post. I said the rear delt is the only bearable site I can tolerate for test e. I've pinned every location I mentioned with the other gear including test-e, I only run into issues with test-e. I won't get to my muscle with a 5/8 needle even on my rear delts. 1 inch yes, I don't need to go all the way with a 1 1/2 inch needle.
Click to expand...
Gotcha. I got the most of it. Not sure what to tell you. Have you used test e before without issues? If so then I'm stumped.

Sent from my SM-G930V using Tapatalk
 
galois said:
Ah, medlab :)

You have a history of pip with E? I think you’ve answered your own question and probably need to switch esters.

Alternatively, split your pin to two sites, each with half the volume so it will be manageable as before.
Click to expand...

The pip lasts for 5ish days, 6 days to be safe, on any site I hit which is why I alternate each rear delt M and F otherwise I won't be able to walk if I pin my quad, won't be able to squat with my glute or ventro (ventro isn't too bad but any trunk twists which I often do to stretch my spine is out of the question. Medial delts become an issue for any lateral lifts and my delt bread and butter are lateral flys. Switching esters sucks cause I have probably 15 vials of test-e.
 
noitangidni said:
The pip lasts for 5ish days, 6 days to be safe, on any site I hit which is why I alternate each rear delt M and F otherwise I won't be able to walk if I pin my quad, won't be able to squat with my glute or ventro (ventro isn't too bad but any trunk twists which I often do to stretch my spine is out of the question. Medial delts become an issue for any lateral lifts and my delt bread and butter are lateral flys. Switching esters sucks cause I have probably 15 vials of test-e.
Click to expand...
I hope someone else can find a reason besides the ester man. That's a shame. Plenty of smart minds here. I'd love to pick those up from you! Haha that's forbidden on here.
I wish you the best of luck.
Mr. T

Sent from my SM-G930V using Tapatalk
 
Any trouble with solvents? Or benzyl benzoate at high percentages? I get pip with high bb levels.

Sent from my SM-G930V using Tapatalk
 
SB Labs
noitangidni said:
The pip lasts for 5ish days, 6 days to be safe, on any site I hit which is why I alternate each rear delt M and F otherwise I won't be able to walk if I pin my quad, won't be able to squat with my glute or ventro (ventro isn't too bad but any trunk twists which I often do to stretch my spine is out of the question. Medial delts become an issue for any lateral lifts and my delt bread and butter are lateral flys. Switching esters sucks cause I have probably 15 vials of test-e.
Click to expand...

Change your pinning schedule and mix tren/EQ with the test to dilute it? At the same time, spread it across more than one site.
 
I get pip from the 500mg enth unless I heat it up.

if I heat it up I don’t feel a thing afterward
 
Take the niacin that makes you itchy and arginine. It makes pip disappear. Your welcome. it causes a flush. Also makes the uptake of said test or androgen metabolize faster.
 
noitangidni said:
As the title says..

Highly doubt it's my technique due to three main key factors:

I was a flight medic in the military for 8 years, so I understand site rotation, proper BSi procedures.
I also use Tren-E 200mg from monster labs and Equipose 200mg from another lab, using the same sites as my test-e shot sites during rotation and experience zero pip.
This isn't my first rodeo.

Right now my cycle is 300mg test-e M and F (600wk)
200mg tren-e 200mg equi every Saturday.

I've gotten to the point where I can only bare using each rear delt since if I use the medial delts, I won't be able to raise my arms laterally past 90degrees. I've tried, ventro, glute, quad, medial, all horrible and immobilizing pain.

I've been a customer since medlabs and I've always had some pip from test-e but I used to only run 300 a wk to cruise with so the pain is manageable. Now that I have a show coming up in 14 weeks, the swelling, a little redness, no heat, makes me worried about posing and looking slightly awkward on stage with lumps on my delts.

As you can see, I still have lots of gear left. Was this just a bad batch? I've gone through 2 vials with the same issues. Any help appreciated. Yes, I've tried running the syringe through hot water prior, yes I use a drawing needle and a 27g 1 1/2 to pin.
Click to expand...
They might use different oil than they do in their other types of gear, and if so, then you might be getting an allergic reaction to that particular type of oil
 
noitangidni said:
As the title says..

Highly doubt it's my technique due to three main key factors:

I was a flight medic in the military for 8 years, so I understand site rotation, proper BSi procedures.
I also use Tren-E 200mg from monster labs and Equipose 200mg from another lab, using the same sites as my test-e shot sites during rotation and experience zero pip.
This isn't my first rodeo.

Right now my cycle is 300mg test-e M and F (600wk)
200mg tren-e 200mg equi every Saturday.

I've gotten to the point where I can only bare using each rear delt since if I use the medial delts, I won't be able to raise my arms laterally past 90degrees. I've tried, ventro, glute, quad, medial, all horrible and immobilizing pain.

I've been a customer since medlabs and I've always had some pip from test-e but I used to only run 300 a wk to cruise with so the pain is manageable. Now that I have a show coming up in 14 weeks, the swelling, a little redness, no heat, makes me worried about posing and looking slightly awkward on stage with lumps on my delts.

As you can see, I still have lots of gear left. Was this just a bad batch? I've gone through 2 vials with the same issues. Any help appreciated. Yes, I've tried running the syringe through hot water prior, yes I use a drawing needle and a 27g 1 1/2 to pin.
Click to expand...

pm me bro.


Not sure whats the problem here, havent had any issues with our Test e 300mg before
 
Like what was said earlier mix the tren and eq with the test that should help out a lot
 
I would maybe mix it with other gear during pinning. work in the trene ad eq with the test and split evenly to doses you are using now? I know on higher mg gear like 400mg/ml sometimes i get a bit of pip but mixing wiht say 0.5ml deca would clear even that up. or even a lower mg/ml test oil with it
 

Latest threads

Back
Top