Warriorblaze
Registered
Today's public service announcement is how to properly heat injectable AAS prior to injection.
1. Draw all compounds into your syringe.
2. Draw .1-.2ml of air into the syringe
3. Cap the drawing needle
4. Start a small stream of warm (not hot) water running in your sink
5. Grasp the syringe by the needle cap and place the barrel of the syringe under the running water
6. Once warmed, replace the drawing needle with a new, sterile needle and proceed with injection.
Notes:
The air bubble in the syringe allows for expansion of the oil.
I believe it is "best practice" to change needles AFTER the gear is warm. The less time the sterile needle is opened prior to injection, the better.
Warrior
1. Draw all compounds into your syringe.
2. Draw .1-.2ml of air into the syringe
3. Cap the drawing needle
4. Start a small stream of warm (not hot) water running in your sink
5. Grasp the syringe by the needle cap and place the barrel of the syringe under the running water
6. Once warmed, replace the drawing needle with a new, sterile needle and proceed with injection.
Notes:
The air bubble in the syringe allows for expansion of the oil.
I believe it is "best practice" to change needles AFTER the gear is warm. The less time the sterile needle is opened prior to injection, the better.
Warrior