Questions about Winter conditions in transit

[itsmekrispy]

Hey all, I was planning on ordering test E, tren E, and DHB, and the northern winters in my area are not friendly this time of year (it was near 0 degrees Fahrenheit this morning). Obviously, the gear is going to crash, and I was planning on buying a heating pad to remedy this.

I am looking for anything I should be aware of for these compounds in specific, and if there is any issues with pip for crashed oils? Thank you all!


Sent from my iPhone using Tapatalk

 

[Bolan]

I also live in the North... Buy your gear in the Summer and GH in the winter!!

You should be fine just putting the vials on a hot plate for a min and shake
Wont take long for it to go back into a solution.
Some people run it under hot water for a little bit.

No PIP issues when it goes back into a solution,
If it crashes again...Toss it.

 

[itsmekrispy]

I also live in the North... Buy your gear in the Summer and GH in the winter!!

You should be fine just putting the vials on a hot plate for a min and shake
Wont take long for it to go back into a solution.
Some people run it under hot water for a little bit.

No PIP issues when it goes back into a solution,
If it crashes again...Toss it.

Noted!! Thank you I appreciate it a lot


Sent from my iPhone using Tapatalk

 

[PRorER]

I always heat up a mug of hot water in the microwave for a min (water maybe 1/3rd height of vial) and let sit for a few minutes. Little light shaking if necessary

 

[dcdogz]

i would not order dhb until its warm its gonna land crashed 100% and is a pain to constantly reheat and pin, its already slightly pippy.

 

[itsmekrispy]

i would not order dhb until its warm its gonna land crashed 100% and is a pain to constantly reheat and pin, its already slightly pippy.

oh wow, so once it crashes in the cold, it just wont go back into solution huh??

 

[MindlessWork]

Simple fix. Put the gear vials you want to use in a sealed baggie and put into a bowl of hot water for 30 minutes then gently shake them to mix any crystals back and the cloudiness should also disappear. make sure the gear isn't too hot before you inject!

 

[itsmekrispy]

Simple fix. Put the gear vials you want to use in a sealed baggie and put into a bowl of hot water for 30 minutes then gently shake them to mix any crystals back and the cloudiness should also disappear. make sure the gear isn't too hot before you inject!

Thank you!! Just didn’t know if the heat would damage the compounds, and if pip was bad with gear that had previously crashed


Sent from my iPhone using Tapatalk

 

[MindlessWork]

Thank you!! Just didn’t know if the heat would damage the compounds, and if pip was bad with gear that had previously crashed


Sent from my iPhone using Tapatalk

Not boiling hot, but hot water from the tap be sufficient.

 

[lottalead]

hot water!

 

[big_rich]

I used a heat pad many times with success, a candle warmer works also a Candle warmer is a cheap option.

 

[itsmekrispy]

I used a heat pad many times with success, a candle warmer works also a Candle warmer is a cheap option.

How is pip after fixing the gear ?


Sent from my iPhone using Tapatalk

 

[dcdogz]

oh wow, so once it crashes in the cold, it just wont go back into solution huh??

Ymmv but it seems most have issues