Beginners Easy Guide to HGH Reconstitution

[Wardamn]

How much bac water do i add in a 40iu vial of GH? Im still learning. ThIs is my first run of GH. TIA!

I would put in 2ml.

 

[Wardamn]

How much bac water do i add in a 40iu vial of GH? Im still learning. ThIs is my first run of GH. TIA!

I would put in 2ml.

 

[Powerhousehb]

I would put in 2ml.

Thanks!

 

[302]

Good post, bro. Simple and easy to follow.
To add, always use BAC water if storing, drizzle slow when mixing, and wipe the vial top every time. HGH is fragile and expensive, so handle it with care.

Only thing I might add, to avoid confusion, is a 1ml. insulin syringe is not 100iu. of anything. It is a 100 units. It’s just a measurement. 100 units = 1ml.
An iu you is not a fixed weight or volume like mgs or mls. It measures the biological effect or potency.
Take any compound concentration. Whatever it may be. let’s say it’s 50 mg of ghk. Then let’s add 5 ml of bac.
50 5 = 10 . I will now have 10mg of ghk in each ml. of my mixture. Each 10 units on a slin pin will be 1 mg of ghk.
This is just an example. I wouldn’t use that much bac water with ghk.

 

[302]

What thing are you used to with ghk?

Not sure I understand your question.

 

[302]

Okay. You said I don't use bac water, so I asked what you use to mix GHK.

I never said that. lol

 

[Wardamn]

Good post, bro. Simple and easy to follow.
To add, always use BAC water if storing, drizzle slow when mixing, and wipe the vial top every time. HGH is fragile and expensive, so handle it with care.

GH is not that fragile. You don't need to drizzle BAC water or let it run down the side. Testing has been done on this.

 

[DeadliftTommy]

Super helpful post for anyone new to HGH clear steps like this make the whole process way less intimidating.

 

[pcf]

Can 2 ml BAC water dissolve 24 IU of Hgh? Thank you!

 

[JB4976]

Can 2 ml BAC water dissolve 24 IU of Hgh? Thank you!

Yep, as can 1ml

 

[Wardamn]

Can 2 ml BAC water dissolve 24 IU of Hgh? Thank you!

Yes, use as much or as little as you like.

 

[OlePhart]

Can 2 ml BAC water dissolve 24 IU of Hgh? Thank you!

Just remember to do the math so you have accurate dosing. i.e. 2.4 mils bac water in your 24iu bottle will give you a 1 to 1 ratio. 10 on your syringe would be 1iu, 20 would be 2ius. So on and so forth.

 

[pcf]

Excellent, thank you! Just wasn’t sure if the full 24 iu’s of powder would dissolve in 2 ml.

 

[nm156]

This thread is very helpful. I wasn't sure on the I.U. versus mg on peptide bottles. I understand petides and the mgs but wasn't sure on the GH fill per milliliter and dosing per microliter. This helps, thanks.

 

[Bloopetron]

I would really recommend filtering in a new sterile vial via the vent method following recon. Super cheap to do and at least takes some of the guess work out in terms of vendor sterility and quality

 

[primalsource]

I would just recommend using Hospira going forward. Some of the new production methods in China are making generic bac water options unusable for reconstituting peptides, causing cloudy mixtures. It's not a purity or quality thing! It's only a ph issue between the peptides and the bac water.

Use Hospira only now!

 

[j2048b]

HGH Calculator

Easiest ever even shows a pic of noodle


Sent from my iPhone using Tapatalk

 

[Slyosniper]

I just googled peptide calculator and it automatically does it for me

 

[celrin321]

I would just recommend using Hospira going forward. Some of the new production methods in China are making generic bac water options unusable for reconstituting peptides, causing cloudy mixtures. It's not a purity or quality thing! It's only a ph issue between the peptides and the bac water.

Use Hospira only now!

Jano did some interview recently and he said people are sending in BAC water for testing and a lot of the time it is just sterile water or even tap water lol

 

[primalsource]

Jano did some interview recently and he said people are sending in BAC water for testing and a lot of the time it is just sterile water or even tap water lol

I used to think the peptide nerds constantly barking about Hospira were just blowing smoke up my ass... well turns out they were right!

 

[Lustyscripps]

How many vials of HGH are you guys reconstituting at a time? 10iu vials specifically

 

[BFulforth]

How many vials of HGH are you guys reconstituting at a time? 10iu vials specifically

I reconstitute one at a time and will reconstitute the next before the first one runs out the next scheduled dose.


Sent from my iPhone using Tapatalk

 

[M2W]

This is super basic but I didn't notice if we have a thread like this stickied or anything so here it is:

HGH mixing (reconstitution) instruction

1) Remove cap on your 10iu multi use vial. 10iu vials seem to be the most common.
Clean rubber stopper with rubbing alcohol swab.

2) Take a syringe and draw up 1 ml of bacteriostatic water (BAC water) Water is just a suspension method for the HGH. The amount isn't super critical. Doesn't matter if you use 1ml or 2ml or 3ml....so on. Just use an exact/even amount so it's easy to measure

Example:

1ml (cc) added to a 10IU vial of HGH means each 10 mark on U100 syringe equals 1 IU of HGH

2ml (cc) added to a 10 IU vial of HGH means each 20 mark on a U100 syringe equal 1 IU of HGH

3ml (cc) added to a 10 IU vial of HGH means the 30 mark on U100 syringe would equal 1 IU of HGH

3.) You now have 1ml of water in the syringe. Insert needle through the rubber stopper at a slight angle. Slowly press plunger and allow BAC water to "drizzle " slowly against side of vial. You don't want to hit the fragile HGH powder with a direct pressure stream of water as it is fragile. Once your BAC water is in vial gently "swirl" it around until all powder is dissolved. You may want to add 1/3 of water at a time swirling gently between each addition.NEVER SHAKE TO MIX!!

4.) Once the powder is dissolved or "reconstituded" the HGH is now ready for use. Store your reconstituted HGH in the refrigerator (36 - 46 degrees Fahrenheit or 2-6 degrees Centigrade)

MEASURING

Determine injectiondosage. You should really know how many ticks on your 1CC insulin syringe contain how much hgh during the reconstitution process

But you simply take the number of IU's of the HGH (lyophilized powder ) divide that into the amount of diluent we used.

Example-

If you used 1cc or a ml of water; into a 10 IU vial of HGH.

1cc = 100 IU's, so you now have 100 IU's of water in vial.

Simply divide 100 IU's (the amount of our water) by 10 IU's (the amount of hGH)

100 IU / 10 IU = 10

This tells you that to draw up 1iu of hgh you need to draw to the 10mark on a 1CC insulin syringe. For 2iu draw to the 20mark, etc...

Ref: How to do reconstitute hgh ?

It's really that simple. Don't forget and leave your vial at room temperature. Put ot back in fridge! Hgh is expensive

Ref: How to do reconstitute hgh ?

 

[M2W]

This is super basic but I didn't notice if we have a thread like this stickied or anything so here it is:

HGH mixing (reconstitution) instruction

1) Remove cap on your 10iu multi use vial. 10iu vials seem to be the most common.
Clean rubber stopper with rubbing alcohol swab.

2) Take a syringe and draw up 1 ml of bacteriostatic water (BAC water) Water is just a suspension method for the HGH. The amount isn't super critical. Doesn't matter if you use 1ml or 2ml or 3ml....so on. Just use an exact/even amount so it's easy to measure

Example:

1ml (cc) added to a 10IU vial of HGH means each 10 mark on U100 syringe equals 1 IU of HGH

2ml (cc) added to a 10 IU vial of HGH means each 20 mark on a U100 syringe equal 1 IU of HGH

3ml (cc) added to a 10 IU vial of HGH means the 30 mark on U100 syringe would equal 1 IU of HGH

3.) You now have 1ml of water in the syringe. Insert needle through the rubber stopper at a slight angle. Slowly press plunger and allow BAC water to "drizzle " slowly against side of vial. You don't want to hit the fragile HGH powder with a direct pressure stream of water as it is fragile. Once your BAC water is in vial gently "swirl" it around until all powder is dissolved. You may want to add 1/3 of water at a time swirling gently between each addition.NEVER SHAKE TO MIX!!

4.) Once the powder is dissolved or "reconstituded" the HGH is now ready for use. Store your reconstituted HGH in the refrigerator (36 - 46 degrees Fahrenheit or 2-6 degrees Centigrade)

MEASURING

Determine injectiondosage. You should really know how many ticks on your 1CC insulin syringe contain how much hgh during the reconstitution process

But you simply take the number of IU's of the HGH (lyophilized powder ) divide that into the amount of diluent we used.

Example-

If you used 1cc or a ml of water; into a 10 IU vial of HGH.

1cc = 100 IU's, so you now have 100 IU's of water in vial.

Simply divide 100 IU's (the amount of our water) by 10 IU's (the amount of hGH)

100 IU / 10 IU = 10

This tells you that to draw up 1iu of hgh you need to draw to the 10mark on a 1CC insulin syringe. For 2iu draw to the 20mark, etc...

Ref: How to do reconstitute hgh ?

It's really that simple. Don't forget and leave your vial at room temperature. Put ot back in fridge! Hgh is expensive

Ref: How to do reconstitute hgh ?

I recently switched from one source to another bc my last 10iu vial in my kit was cloudy.
Now this new kit is cloudy and yellowish tint.
Anyone have these issuse?