Mixing or blending. Why or why not

[Twistedfords]

Now don't blast me for this question. It's more or less curiosity on my part.

If you are taking test c twice a week. And you add in another compound like trest , dhb , primo or something else , 2 times a week also. Assuming it's the same ester or half life. Can you limit the number of shots taken and some how blend the two in the same syringe? Or in a extra sealed bottle? I know I have read a 100 times that guys do this. I never have. Just wondering how you do this in a safe manner. Do they have to be the same carrier oils? Do the mixing chemicals have to be the same?

I have read it is done. But I have never read how it is done. Most guys try this to smooth out the pip with the test oil.

 

[ruffus]

I have mixed oils together in syringes as well as vials for decades without worrying about it. I Mix water based things together as well. I just don't mix the water and oil based together.

 

[McBoobenheim]

You can mix oil with oil and water with water to your hearts content. Just don't mix water and oil

 

[TomJ]

Blends, in general, are going to be more problematic than single compound preparations.
You dont have the ability to adjust dosage, they are generally higher concentration and more likely to cause PIP, they will be less consistent in their preparation in most cases.

IMO the only benefit of blends is potentially lower injection volume vs a ton of negatives.
There is no situation where I personally will use blends.

 

[Twistedfords]

Blends, in general, are going to be more problematic than single compound preparations.
You dont have the ability to adjust dosage, they are generally higher concentration and more likely to cause PIP, they will be less consistent in their preparation in most cases.

IMO the only benefit of blends is potentially lower injection volume vs a ton of negatives.
There is no situation where I personally will use blends.

I don't buy blends also for the same reason. But if you know your amounts you normally use on a weekly basis, was wondering how guys were using there test cyp to thin out another compound that was giving them pip issues. And everyone said you can just draw up both into the same syringe.

 

[McBoobenheim]

I simply draw up, say, 250 mg test in the syringe, then draw up, say, 100mg NPP is the same syringe then pin. I've never found a need to mix them in the same vial.

 

[Wardamn]

I don't buy blends also for the same reason. But if you know your amounts you normally use on a weekly basis, was wondering how guys were using there test cyp to thin out another compound that was giving them pip issues. And everyone said you can just draw up both into the same syringe.

You just draw both into the syringe. Pretty simple.

 

[Syntha Claus]

Not that it is a good idea, actually, it’s a bad one but…
I used to see guys mix their test and deca with winstrol in the same syringe.
None of them died.
I mean, they might be dead now as this was well over 30 years ago, but none died back then.

I am not a fan of mixing in a syringe, steroids with different carrier oils. Other than that, mix away. I actually leave a big enough air bubble to tilt back and forth, mixing the tren with whatever else is in there. It sort of buffers the tren, decreasing chances of “tren cough”.

 

[heckler7]

I had some fire blends that were the best gear I ever run

 

[GonadalGooner88]

Currently running a "homemade" blend of Test mast tren. You draw a sterile oil and move it to another sterile vial, it will remain sterile...
Maybe there is some "risk" of inaccurate dosing, but on the average you will be taking it at whatever you have the mix compounds at.

For example if you mix 1ml of Test 200 and 1ml of Tren 200, you might get a different dose of either on any random injection, but on the aggregate you will be getting Equal parts test and tren.

Now peptides I don't mix because they're much more fragile...

Sent from my SM-S938U1 using Tapatalk

 

[Phill]

Now don't blast me for this question. It's more or less curiosity on my part.

If you are taking test c twice a week. And you add in another compound like trest , dhb , primo or something else , 2 times a week also. Assuming it's the same ester or half life. Can you limit the number of shots taken and some how blend the two in the same syringe? Or in a extra sealed bottle? I know I have read a 100 times that guys do this. I never have. Just wondering how you do this in a safe manner. Do they have to be the same carrier oils? Do the mixing chemicals have to be the same?

I have read it is done. But I have never read how it is done. Most guys try this to smooth out the pip with the test oil.

you are confusing blends (two products cooked in one), with mixing two different products.
there is a big difference.

which one are you referring to? what are we talking about exactly?

 

[Twistedfords]

We are talking about two different products. Not cooking one product with two substances. In regards to pip some guys use their test to thin out the other compound in the same syringe. So like test c one bottle draw up. Then second bottle of like Trest or DHB. Same syringe being used. This way the extra oil can dilute the treat or DHB a little.

 

[Phill]

yes, I mix different products every day.
you have a little more volume to inject, but one less hole in the muscle.
as long as the volume remains acceptable, I prefer to mix