PIP advice

Page 4 of 4 FirstFirst 1234
Results 46 to 49 of 49

Thread: PIP advice

  1. #46
    Registered User
    zionoir626's Avatar


    Join Date
    Dec 2013
    Location
    Blue Ridge
    Posts
    5,145

    Thanks Thanks Given 
    1,482
    Thanks Thanks Received 
    2,639
    Thanked in
    1,647 Posts
    Rep Points
    2147483647

    My Injection and heating protocols
    1...Wash hands before touching any vials.
    2... Alcohol the vail stopper
    3... I use a 20g loader needle... submerge it in Alcohol
    4... open a new needle syringe(I always use BD)..take the needle off,don't take the needle out of the wrapper(putting on a dirty sink is bad Mojo)
    5...pull 2cc's of air to flush the Alcohol out of the loader needle..
    6...attach loader,flush with air,the pull 2 cc's..
    7... inject air into vail and pull desired amout of gear..

    Now if it's over 1cc I usually heat for better absorption..
    1...heat 2 cup of water in the Mic for 2 mins. to boil...
    2... allow to cool for a min. or 2..Then drop the syringe in..
    3...after a min or less,quickly swap loader for the new needle..
    4...prep injection spot with alcohol,inject with a slight downward angle(take between 20-30)
    5... remove,alcohol area..and massage for about min.
    6...please dispose of sharps in a safe manner...Please

    I was handed down some of this from the Now Gone Warrior Blaze...and added a few things as time went on..Knocking on my night table right now..I have never had an infection..bad shots,well Hell yes,Hazmat scenes a few times..But nothing that knocked me out-of-the box..

    I'm sure some of you have found some other/better ways over the yrs..
    Hope this helps some..

  2. #47
    Registered User
    BodybuilderZepp's Avatar


    Join Date
    Oct 2019
    Location
    Your Basement
    Posts
    2,576

    Thanks Thanks Given 
    2,155
    Thanks Thanks Received 
    4,006
    Thanked in
    1,558 Posts
    Rep Points
    42164276

    Since its getting cold we can also add the old trick of using a hair dryer if you see crystals in your vial. Or putting in on the stove top.

    Heating before pinning was never something I liked. I didnít like the risk of injecting something hot inside me.

    22g draw always seemed to work better than 21 or 20 because eventually you will get rubber from the stopper to go on your vial. Also depending how many times your pricking the vial. If your doing 1cc or more shots 20g is fine, but if your doing 1/2cc shots or less some rubber stoppers are cheaper than others and pieces will go in the oil eventually.

    25g 1 inch to inject, and do that size in my glutes, quads, lats, shoulders, traps and chest with no problems.

  3. #48
    Registered User
    zionoir626's Avatar


    Join Date
    Dec 2013
    Location
    Blue Ridge
    Posts
    5,145

    Thanks Thanks Given 
    1,482
    Thanks Thanks Received 
    2,639
    Thanked in
    1,647 Posts
    Rep Points
    2147483647

    I forget where I got it from...but the vial heating if crystals exist..I try a lot but this one seemed to work the Best for me..
    You put a needle in the stopper to relieve air..but it doesn't touch the oil..in the oven on 180 degrees..put the vial in a pot but no water..
    Then wait 15 to 20 minutes and shake like hell..

    Only had a few with crystals in them..this worked on all but one,tossed..

  4. #49
    Registered User
    zionoir626's Avatar


    Join Date
    Dec 2013
    Location
    Blue Ridge
    Posts
    5,145

    Thanks Thanks Given 
    1,482
    Thanks Thanks Received 
    2,639
    Thanked in
    1,647 Posts
    Rep Points
    2147483647

    As before mentioned this...PIP is just part of the game...but being prepared for sideways turns is smart..
    Like having a strong AI incase you need it and having some antibiotics stashed for day in Question..

    Point on this post is to be prepared..Know what to do when this happens

    But know When to throw in the Towel and get medical attention..the antibiotics can take some worry out and give you some more time before getting help..BUT without anti's If things don't improve and Only get worse...better to be safe than sorry..

Similar Threads

  1. Greetings and advice welcome
    By Kingsranger in forum New Members
    Replies: 4
    Last Post: 06-10-2019, 06:05 AM
  2. HGH; advice
    By carpenter4life71 in forum Anabolic Steroids
    Replies: 5
    Last Post: 07-04-2015, 07:36 AM
  3. Need advice.
    By Kendrxck in forum Anabolic Steroids
    Replies: 26
    Last Post: 06-23-2015, 04:05 PM
  4. need advice for hrt
    By tinknocker216 in forum Testosterone Replacement Therapy
    Replies: 10
    Last Post: 05-13-2015, 03:13 PM
  5. Need some advice
    By Lloyd G in forum Anabolic Steroids
    Replies: 1
    Last Post: 02-13-2014, 06:19 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Copyright© 2012-2022 Anabolic Steroid Discussion Forums