Search results

  1. Hacks909

    Equipoise undecy and Mast e displacement

    Thank you I already had these from the other post, just couldn’t fine the two I was looking for. I did look elsewhere and found them. Do I trust the source? Not as much as vets on here but will have to do the trick. Much appreciated!
  2. Hacks909

    which is the best carrier oil ?

    For my homebrew I used GSO and it’s as smooth as butter. I’ve purchase gear from UGL and they have used MCT 60/40 I didn’t have any issues with that either. But if I would to choose one from the other I would use GSO.
  3. Hacks909

    Equipoise undecy and Mast e displacement

    Can anyone provide EQ and Mast e displacement? Much appreciated it.
  4. Hacks909

    Homebrew Thread: Recipes, advice, general discussion...

    Need displacement for EQ and drostanolone enanthate? Recipe for Mast E I’m brewing for 200mg/ml =30ml Is 2%BA/20%BB good enough using GSO?
  5. Hacks909

    Adding EQ to cycle

    I always see post people crashing E due to mast, primo and EQ. I appreciate the info. I already run Mast e with my Cruze all year at low dose. I’ll bump it up to 400mg with the rest of my stack.
  6. Hacks909

    Adding EQ to cycle

    I always see post people crashing E due to mast, primo and EQ
  7. Hacks909

    Adding EQ to cycle

    Will both DHT crash my estrogen? Should I run test higher?
  8. Hacks909

    Adding EQ to cycle

    so your saying… Primo 600mg/wk Test c 500mg/wk Mast 400mg/wk 12 weeks?
  9. Hacks909

    Adding EQ to cycle

    As much as I would like to grow 19-nor are no good for my D**k. libido goes down and so does he even on caber.
  10. Hacks909

    Adding EQ to cycle

    I’ve ran EQ last year and found good results. I was running… Test c 500mg EQ 700mg Proviron 25mg/day Gained 10 clean pounds.
  11. Hacks909

    Adding EQ to cycle

    Would adding EQ to a Primo E and Test C be worth it? I’m thinking…. Primo 600mg/wk Test C 500mg/wk EQ 400-600mg/wk 20 week cycle
  12. Hacks909

    First homebrew!

    Thanks brotha, it’s not as hard as you may think it is. You just need some patience and a little of common sense. The hardest part is getting the dang juice through filter into bottle. And yes, great feeling to see this beautiful bottle and pinning it.
  13. Hacks909

    Primo homebrew??

    This is the way.
  14. Hacks909

    First homebrew!

    34hrs from brewing primo and looked good no crash as of yet I hope. Couldn’t wait so I pinned 300mg 1-1/2cc and it was smooth as butter.
  15. Hacks909

    First homebrew!

    18hrs and still holding well, will wait until tomorrow morning then I’m pinning.
  16. Hacks909

    First homebrew!

    No one answered my question that is certain. How long should I wait to pin after brewing, when would I know if the brew isn’t or is stable?
  17. Hacks909

    First homebrew!

    Going to place an order, thank you. I have one question though, if bottle is on its side (laying) for extended amount of time will it drip out? I seen video and bottle is turned upside down but for a very short period of time.
  18. Hacks909

    First homebrew!

    Thank you,
  19. Hacks909

    First homebrew!

    Will be running 600mg/week, stopper will be pinned approx 40x. I have another 30ml bottle. After I see that stopper going bad should I or can I transfer over to 30ml bottle? I never thought of that. 🤦🏻‍♂️
  20. Hacks909

    First homebrew!

    Thank you! It feels freaking great!!! What’s even better is that I brewed the primo at the fraction of the cost.
Top